Abs plastic strip specification
Material : ABS
Color : Black
Height : 21mm
Width : 35mm
Thickness : 2mm
Weight : 180g/meter
ABS material properties
1、 Conventional performance plastic ABS is non-toxic and tasteless, and its appearance is ivory translucent, or transparent particles or powder. The density is 1.05 ~ 1.18g/cm3, the shrinkage is 0.4% ~ 0.9%, the elastic modulus is 2gpa, the Poisson’s ratio is 0.394, the moisture absorption is < 1%, the melting temperature is 217 ~ 237 ℃, and the thermal decomposition temperature is > 250 ℃.
2、 Mechanical properties plastic ABS has excellent mechanical properties and excellent impact strength, which can be used at very low temperature; Plastic ABS has excellent wear resistance, good dimensional stability and oil resistance. It can be used for bearings under medium load and low speed. The creep resistance of ABS is larger than PSF and PC, but smaller than PA and POM.
3、 The thermal deformation temperature of thermal performance plastic ABS is 93 ~ 118 ℃, and the product can be increased by about 10 ℃ after annealing. ABS can still show certain toughness at – 40 ℃ and can be used in the temperature range of – 40 ~ 100 ℃.
4、 Electrical performance plastic ABS has good electrical insulation, and is hardly affected by temperature, humidity and frequency. It can be used in most environments. 5、 Environmental performance plastic ABS is not affected by water, inorganic salts, alkali and a variety of acids, but can be dissolved in ketones, aldehydes and chlorinated hydrocarbons. It will produce stress cracking due to the erosion of glacial acetic acid and vegetable oil. ABS has poor weather resistance and is easy to degrade under the action of ultraviolet light; After half a year outdoor, the impact strength decreased by half.
ABS plastic contains two materials, one of which is easy to deform compared with the other, so the plastic surface produced by melt front rolling is essentially uneven in the order of microns. The best gloss depends on clinging this uneven new surface to the highly polished mold surface. Although it is always expected that higher melt temperature will be conducive to improving gloss, But in most cases, the opposite is true, especially in cold molds
Some grades of ABS plastics are not very sensitive, so the performance response curve is relatively flat. Undercooling of the melt will also reduce the gloss, because the filling is hindered. Because the overall performance response curve is a bow back curve. The mold temperature has a strong impact on the gloss. The cold mold (below 1400F) reduces the available gloss, At the same time, other forming parameters are more sensitive to gloss. Higher die temperature (150 ~ 1800f) improves gloss and reduces the influence of melt temperature
abs plastic strip picture:
Tooling/Mould development time
We can according your drawing to make new tooling/mould for it,usually it takes 15 days,
and we will sent sample to you for checking,after your confirm the sample,we can start
process the order.
we can customize cartons, cardboard, wooden cases, pallets and label paper according to customer packaging requirements.
Trade Term:EXW/FOB/FCA.
Hot Tags: abs plastic strip, China, suppliers, manufacturers, factory, customized, buy, made in China
